Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 14
items per page: 25 50 75
Sort by:

Abstract

The reliable and rapid diagnosis of infectious animal diseases presents an exceptionally im- portant aspect when considering their control and prevention. The paper describes the compara- tive evaluation of two rapid isothermal amplification methods for diagnosis of African swine fever (ASF). The robustness of loop-mediated isothermal amplification (LAMP) and the cross-priming amplification (CPA) were compared using samples obtained from ASF confirmed animals. Both assays were evaluated in order to define their diagnostic capabilities in terms of ASF diagnosis and reproducibility of the results. Investigations showed no cross-reactivity for other pig patho- gens and no significant differences in the specificity of both assays. The sensitivity of LAMP reached 90%, while that of CPA was 70%. In conclusion, both methods are suitable for imple- mentation in preliminary ASF diagnosis but further improvements are required to enhance their diagnostic sensitivity.
Go to article

Abstract

The article refers to the idea of using the software defined network (SDN) as an effective hardware and software platform enabling the creation and dynamic management of distributed ICT infrastructure supporting the rapid prototyping process. The authors proposed a new layered reference model remote distributed rapid prototyping that allows the development of heterogeneous, open systems of rapid prototyping in a distributed environment. Next, the implementation of this model was presented in which the functioning of the bottom layers of the model is based on the SDN architecture. Laboratory tests were carried out for this implementation which allowed to verify the proposed model in the real environment, as well as determine its potential and possibilities for further development. Thus, the approach described in the paper may contribute to the development and improvement of the efficiency of rapid prototyping processes which individual components are located in remote industrial, research and development units. Thanks to this, it will be possible to better integrate production processes as well as optimize the costs associated with prototyping. The proposed solution is also a response in this regard to the needs of industry 4.0 in the area of creating scalable, controllable and reliable platforms.
Go to article

Abstract

Simulation software can be used not only for checking the correctness of a particular design but also for finding rules which could be used in majority of future designs. In the present work the recommendations for optimal distance between a side feeder and a casting wall were formulated. The shrinkage problems with application of side feeders may arise from overheating of the moulding sand layer between casting wall and the feeder in case the neck is too short as well as formation of a hot spot at the junction of the neck and the casting. A large number of simulations using commercial software were carried out, in which the main independent variables were: the feeder’s neck length, type and geometry of the feeder, as well as geometry and material of the casting. It was found that the shrinkage defects do not appear for tubular castings, whereas for flat walled castings the neck length and the feeders’ geometry are important parameters to be set properly in order to avoid the shrinkage defects. The rules for optimal lengths were found using the Rough Sets Theory approach, separately for traditional and exothermic feeders.
Go to article

This page uses 'cookies'. Learn more