An understanding of the fundamental correlation between grain size and material damping is crucial for the successful development of structural components offering high strength and good mechanical energy absorption. With this regard, we fabricated aluminum sheets with grain sizes ranging from tens of microns down to 60 nm and investigated their tensile properties and mechanical damping behavior. An obvious transition of the damping mechanism was observed at nanoscale grain sizes, and the underlying causes by grain boundaries were interpreted.
The objective of this study was to investigate the dependence of the room temperature tensile properties on the volume fraction of discontinuous precipitates (DPs) in a cast AZ91 magnesium alloy. In order to obtain various volume fractions of DPs, the solution-treated alloy was aged at 428 K for up to 48 h. The volume fraction of DPs increased from 0% to 72% with an increase in the aging time up to 24 h; for aging times longer than 24 h, discontinuous precipitation was substantially inhibited owing to the occurrence of significant continuous precipitation within the α-(Mg) grains. YS and UTS of the alloy increased with the volume fraction of DPs, whereas the elongation showed a reverse trend. A relatively rapid change in the tensile properties with increasing volume fraction of DPs up to ~40% was noted, which would be due to the reduction of the effective α grain size in response to the formation of DPs along the grain boundaries.
The results presented in this paper are a continuation of the previously published studies. The results of hest treatment of ductile iron with content 3,66%Si and 3,80% Si were produced. The experimental castings were subjected to austempering process for time 30, 60 and 90 minutes at temperature 300o C. The mechanical properties of heat treated specimens were studied using tensile testing and hardness measurement, while microstructures were evaluated with conventional metallographic observations. It was again stated that austempering of high silicone ferritic matrix ductile iron allowed producing ADI-type cast iron with mechanical properties comparable with standard ADI.
Ductile iron casts with a higher silicone content were produced. The austempering process of high silicone ductile iron involving different austempering times was studied and the results presented. The results of metallographical observations and tensile strength tests were offered. The obtained results point to the fact that the silicone content which is considered as acceptable in the literature may in fact be exceeded. The issue is viewed as requiring further research.