Search results

Filters

  • Journals
  • Date

Search results

Number of results: 4
items per page: 25 50 75
Sort by:

Abstract

The paper analyzes, from the geometrical aspect, the quality of the new flux cored wire intended for cladding process in function of changes in cladding parameters such as welding speed, coefficient of thermal conductivity, power source setting, the length of projecting portion of the electrode. The results of bead geometry analysis allows to illustrate the nature of the impact of the examined input variables on parameters of generated surface. The most important parameters here are the depth of penetration and the height of clad. The experimental data were processed using the Plackett-Burman experiment, which describes the impact of technological parameters on the main parameters used during production of resisting panels. It shows mathematical relations describing correlations between the input parameters and the value of depth of penetration and hight of bead made by Flux Cored Arc Welding (FCAW).
Go to article

Abstract

This study stacked a thin, dense BCuP-5 (Cu-Ag-P based filler metal) on a Cu-plate using the laser cladding (L.C) process to develop a method to manufacture Ag reducing multilayer clad electrical contact material with an Ag-M(O)/Ag/Cu/BCuP-5 structure. Then, the microstructure and macroscopic properties of the manufactured BCuP-5 coating layer were analyzed. The thickness of the manufactured coating layer was approximately 1.7 mm (maximum). Microstructural observation of the coating layer identified Cu, Ag and Cu-Ag-Cu3P ternary eutectic phases like those in the initial BcuP-5 powder. To evaluate the properties of the manufactured coating layer, hardness and adhesion strength tests were performed. The average hardness of the laser cladded coating layer was 183.2 Hv, which is 2.6 times greater than conventional brazed BcuP-5. The average pull-off strength measured using the stud pull test was 341.6 kg/cm2. Cross-sectional observation of the pulled-off material confirmed that the coating layer and substrate maintained a firm adhesion after pull-off. Thus, the actual adhesion strength of Cu/BcuP-5 was inferred to be greater than 341.6 kg/cm2. Based on the above findings, it was confirmed that it is possible to manufacture a sound Ag reducing multilayer clad electrical contact material using the laser cladding process.
Go to article

Abstract

Railway buffers during the operation are staying in almost permanent contact with each other, creating friction node in the point of contact of two railway buffer heads. In consequence of overcoming track curves, turnouts and unevenness of track, the railway buffer heads moves relative to each other causing friction, which results in its wear. When the wear is excessive, it might be a reason to withdrawn vehicle from service, it causes flattening of buffer head, and in consequence its abnormal cooperation. To avoid this phenomenon the buffer heads should be covered with graphitized grease, but this method has many disadvantages. Accordingly, it was found that it would be beneficial to cover the buffer head with bronze using laser cladding. In this article the metallographic and mechanical analysis of the newly created top layer of railway buffer head are presented. In article the results from tribological tests conducted on Amsler test bench are also presented. Based on test results described in article concluded that the layer of bronze coat on working surface of railway buffer head can be beneficial from operational point of view.
Go to article

This page uses 'cookies'. Learn more