In order to improve the efficiency and ensure the security of power supply used in a mine, this paper mainly studies the quasi-resonant flyback secondary power supply and analyzes its operational principles based on the requirements of soft-switching technology. In accordance with the maximum energy of a short-circuit and the request of maximum output voltage ripple, this paper calculates the spectrum value of the output filter capacitor and provides its design and procedures to determine the parameters of the main circuit of power supply. The correctness and availability of this theory are eventually validated by experiments.
Due to different reasons a significant modal shift from railway to road transport took place over last decades. The basic reasons are pointed in the paper introduction together with contradicting transport policy taking into account environmental and economical challenges. Political vision to stimulate modal shift from road and air to railway cannot become true without achieving railway technical and operational interoperability. Paper describes wide range of technical barriers between individual intraoperable railway systems in civil engineering structures, traction power supply, control command and signalling and the ways, which are being applied to ensure stepwise converging of the technical solutions taking into account safety and technical compatibility, as well as other essential requirements, namely: reliability, accessibility, health and environment.
The article concerns safety of power supply for the final consumers, especially its two comprising elements, which are generation adequacy and distribution system reliability. Generation adequacy has been defined with Loss of Load Probability (LOLP), Loss of Load Expectation (LOLE) and Energy Not Supplied (ENS) indices. Conclusions from generation adequacy forecast prepared by ENSTO-E for Poland compared with other European countries for the years 2020 and 2025 have been discussed along with the resulting threats. Interruptions in energy supply have been characterised by power discontinuity indicator SAIDI. Finally, a reliability and adequacy analysis have been performed for different scenarios of the Polish power system operation in order to assess possibilities of using distributed generation as a backup power source. Based on a simulation model created using the DIgSILENT Power Factory software, the reliability and adequacy calculations have been performed with the probabilistic non-sequential Monte Carlo method and they are followed by a discussion of the obtained results.
The paper looks at the issues of operation safety of the national power grid and the characteristics of the national power grid in the areas of transmission and distribution. The issues of operation safety of the national transmission and distribution grid were discussed as well as threats to operation safety and security of the electricity supply related to these grids. Failures in the transmission and distribution grid in 2017, caused by extreme weather conditions such as: a violent storm at the night of 11/12.08.2017, hurricane Ksawery on 5–8.10.2017, and hurricane Grzegorz on 29–30.10.2017, the effects of which affected tens of thousands of electricity consumers and led to significant interruptions in the supply of electricity were presented. At present, the national power (transmission and distribution) grid does not pose a threat to the operation safety and security of the electricity supply, and is adapted to the current typical conditions of electricity demand and the performance of tasks during a normal state of affairs, but locally may pose threats, especially in extreme weather conditions. A potentially high threat to the operation safety of the national power grid is closely linked to: age, technical condition and the degree of depletion of the transmission and distribution grids, and their high failure rate due to weather anomalies. Therefore, it is necessary to develop and modernize the 400 and 220 kV transmission grids, cross-border interconnections, and the 110 kV distribution grid (especially in the area of large urban agglomerations), and the MV distribution grid (especially in rural areas). The challenges faced by the transmission and distribution grid operators within the scope of investment and operating activities, with a view to avoiding or at least reducing the scale of grid failures in the case of future sudden high-intensity atmospheric phenomena, are presented.