Search results

Filters

  • Journals

Search results

Number of results: 2
items per page: 25 50 75
Sort by:

Abstract

The article presents the results of the analysis of straw obtained from ripening wheat, which was subjected to four water soaking cycles in demineralized water. The soaking was carried out under laboratory conditions at 20°C. As a result, part of mineral matter, including a significant amount of alkaline sodium and potassium salts and substances containing sulfur and phosphorus, was washed out. The process of soaking has a great impact on the chemical composition of ash obtained from water-treated straw, which increased its acidity. The Na2O content in the analyzed ash has decreased by 78%, while the K2O content has decreased by 60%. In turn, the content of water-insoluble, acid-forming SiO2 has increased by 80%. As a consequence, a positive change in the values of indices, on the basis of which the tendency of straw to slagging and deposit formation during the combustion and gasification processes is assessed, has been observed. Already after the second water soaking cycle it became apparent, based on the AI alkali index, that the examined fuel should not cause difficulties resulting from the increased intensity of use of the boiler during the combustion process. Meanwhile, the value of the BAI bed agglomeration index was considered to be safe, indicating a low possibility of bed agglomeration during the combustion or fluidized bed gasification, after the third water soaking cycle. The third of the analyzed indices, the Fu fouling index, did not indicate any tendency to deposit formation during the combustion; however, four water soaking cycles reduced its initial value by 80%. The last of the analyzed indexes, the SR, slag viscosity index did not change its value during the experiment, which, both for the raw straw and after subsequent soaking cycles, indicated that the fuel should have a low tendency to accumulate slag during the combustion process.
Go to article

Abstract

Eco-friendly leather processes based on the usage of natural products have become a potentially attractive issue for leather industry during the last few decades. Synthetic protective chemicals like bactericides used in most soaking process are known as hazardous substances and cause tannery effluents with high concentrations of Chemical Oxygen Demand (COD). In the present study, the effect of tannic acid on microorganisms, skin, wool and effluent were investigated in order to demonstrate the applicability of tannic acid in soaking process instead of commonly used bactericides. The bacterial load (cfu/ml), COD and Nitrogen Content (N) of the soaking effluents and Total Kjeldahl Nitrogen (TKN) content of skins and wools were investigated. Application of 0.5 and 1 wt% tannic acid concentrations was more effective than commercial bactericide, while comparable results were achieved by 0.1 and 0.3 wt% tannic acid. The application of tannic acid for soaking process resulted in lower COD and N values of effluents. The results show that tannic acid has the potential to be an alternative, eco-friendly bactericide for leather industry by reducing the pollution of leather soaking process.
Go to article

This page uses 'cookies'. Learn more