This paper analyses the changes in transfer characteristics of the vocal tract when closed by a mask, i.e. a chamber. The analysis was performed in two ways: by analytical estimation and by measurements in the vocal tract physical model for the case of mask with inner volume V = 430 cm3, corresponding to the oxygen masks used in combat airplanes. It was shown that closing the vocal tract with a mask cavity increases the first formant frequency by about 10% in front and high vowels (/e/, /i/, and /u/) and the frequencies of the first two formants by about 5% in the remaining two vowels (/a/ and /o/). It was also revealed that longitudinal and transversal resonances in the mask chamber can lead to errors in the recognition of the vowel formant frequencies. The results point to the need for additional knowledge about resonances in mask application.
Problems associated with designing silencers are presented. Results of direct tests of silencers for cooperation with systems of axial fans, as well as results of numerical tests of a two stage acoustic silencer, are given. The numerical tests enabled determining the distribution of acoustic field inside the silencer and in the surrounding area. In those tests A sound insertion losses for different variants of installation inside the silencer, as well as for two different types of absorbing material used to fill the silencer walls, were determined. Impact of design features of silencers on effectiveness of noise reduction is described. Also, a technical sketch of a universal silencer with significant noise reduction (DipS = 39:1 dB) which can be successfully used in many ventilation systems is presented
Detection and identification of toxic environmental gases have assumed paramount importance precisely in the defense, industrial and civilian security sector. Numerous methods have been developed for the sensing of toxic gases in the environment ever since surface acoustic wave (SAW) technology came into existence. Such SAW sensors called electronic nose (E-Nose) sensor use the frequency response of a delay line/resonator. SAW device is focused and given importance. The selective coating between input and output interdigital transducers (IDTs) in the SAW device is responsible for corresponding changes in operating frequency of the device for a specific gas/vapour absorbed from the environment. A suitable combination of well-designed SAW delay lines with selective coatings not only help to improve sensor sensitivity and selectivity but also leads to the minimization of false frequency alarms in the E-Nose sensor. This article presents a comprehensive review of design, development, simulation and modelling of a SAW sensor for potential sensing of toxic environmental gases.
Micro perforated panel (MPP) absorber is a new form of acoustic absorbing material in comparison with porous ones. These absorbers are considered as next generation ones and the best alternative for traditional porous materials like foams. MPP combined with a uniform air gap constructs an absorber which has high absorption but in a narrow bandwidth of frequency. This characteristic makes MPPAs insufficient for practical purposes in comparison with porous materials. In this study instead of using a uniform air gap behind the MPP, the cavity is divided into several partitions with different depth arrangement which have parallel faces. This method improves the absorption bandwidth to reach the looked for goal. To achieve theoretical absorption of this absorber, equivalent electro-acoustic circuit and Maa’s theory (Maa, 1998) are employed. Maa suggested formulas to calculate MPP’s impedance which show good match with experimental results carried out in previous studies. Electro-acoustic analogy is used to combine MPP’s impedance with acoustic impedances of complex partitioned cavity. To verify the theoretical analyses, constructed samples are experimentally tested via impedance tube. To establish the test, a multi-depth setup facing a MPP is inserted into impedance tube and the absorption coefficient is examined in the 63–1600 Hz frequency range. Theoretical results show good agreement compared to measured data, by which a conclusion can be made that partitioning the cavity behind MPP into different depths will improve absorption bandwidth and the electro-acoustic analogy is an appropriate theoretical method for absorption enhancement research, although an optimisation process is needed to achieve best results to prove the capability of this absorber. The optimisation process provides maximum possible absorption in a desired frequency range for a specified cavity configuration by giving the proper cavity depths. In this article numerical optimisation has been done to find cavity depths for a unique MPP.