Search results

Filters

  • Journals
  • Date

Search results

Number of results: 7
items per page: 25 50 75
Sort by:

Abstract

Industrial utilization of fly ash from various kinds of fuel plays an important role in the envi-ronmentally clean and cost effective power production. The primary market for fly ash utilizationis as a pozzolanic addition in concrete production. The paper concerns the concretes containingfly ash called Fly Ash from Biomass (FAB) from co-combustion of hard coal and wood biomass(wood chips). Characterization of the fly ash was carried on by means of X-ray diffractometryand E-SEM/EDS analysis. The results of laboratory studies undertaken to evaluate the influence of FAB on concrete resistance to surface scaling due to cyclic freezing and thawing in the presenceof NaCl solution were presented. The tests were carried out for concretes containing up to 25% offly ash related to cement mass. Additionally, the microstructure of air-voids was described. It was concluded that the FAB has significant effect on concrete freeze/thaw durability. The re-placement of cement by fly ash from co-combustion progressively transformed the concrete mi-crostructure into less resistant against freeze/thaw cycles and excessive dosage (over 15%) maydangerously increase the scaling.
Go to article

Abstract

The objective of this investigation was to test the effectiveness of the Acoustic Emission (AE) measurements in determining the critical stresses during four-point bending of mortar beams. Within the measuring procedure the parameter σcr/σ300 was calculated and analysed. Additionally, the influence of cement replacement by high calcium fly ash (HCFA) on the process of crack healing was discussed. Mortar beams with different content of HCFA and reinforced by steel microfibres were prepared for tests. After curing in standard conditions the beams were subjected to four-point bending test in order to introduce the pre-cracking. Thereafter the beams were cured in the lime water and loaded after 56 and 112 days in the same way as for the first time. Additionally the microstructure of mortars was studied in a stereo optical microscope as well in an electron scanning microscope including the Energy Dispersive X-ray analysis (EDX). The results of microstructural characterization of mortar containing HCFA from lignite combustion are presented. The applied load level slightly exceeded the critical stress, producing intense crack growth processes however did not significant affected the load capacity of the beams. During the consecutive loading the decreasing tendency of σcr/σ300 ratio was noted. The obtained results confirm that the latter parameter can be applied as a measure of the composite degradation level for the elements carrying the repeated loads of amplitude close to the critical stress of the structure and also that the cement replacement with HCFA influences the process of crack healing.
Go to article

This page uses 'cookies'. Learn more