During drilling through aquifers using the rotary drilling method with drilling fluid application, the phenomenon of formation clogging in near-well zone takes place. This leads to physical changes in pore spaces in consequence of the deposition solid phase particles originating from the drilling fluid. Due to this fact, filtration velocity in the clogged zones of the aquifer formation decreases, which results in increased pressure drawdown and decreased well hydraulic efficiency. Therefore, it causes a reduction of the well total capacity. The article consists of studies connected to the development of the mud which will constitute the basis for a complex mud system intended for hydrogeological drilling in different encountered geological conditions. In the framework of laboratory research, technological parameters of six, commonly applied in oil and gas industry, polymer agents as well as new agent developed at the Drilling, Oil and Gas Faculty AGH-UST in Krakow were examined. The undertaken studies showed that the new agent, marked as CAGEx, provides the required technological parameters and can be applied as a base for drilling muds intended for hydrogeological drilling. The undertaken industrial research of the new CAGEx drilling mud carried out while drilling water intake well, confirmed the great stability of its technological parameters as well as insignificant influence on rock permeability damage in filter zone. The water intake well is characterized by high hydraulic efficiency and does not require additional activation treatment.