The fixation of CO2 in the form of inorganic carbonates, also known as mineral carbonation, is an interesting option for the removal of carbon dioxide from various gas streams. The captured CO2 is reacted with metal-oxide bearing materials, usually naturally occurring minerals. The alkaline industrial waste, such as fly ash can also be considered as a source of calcium or magnesium. In the present study the solubility of fly ash from conventional pulverised hard coal fired boilers, with and without desulphurisation products, and fly ash from lignite fluidised bed combustion, generated by Polish power stations was analysed. The principal objective was to assess the potential of fly ash used as a reactant in the process of mineral carbonation. Experiments were done in a 1 dm3 reactor equipped with a heating jacket and a stirrer. The rate of dissolution in water and in acid solutions was measured at various temperatures (20 - 80ºC), waste-to-solvent ratios (1:100 - 1:4) and stirrer speeds (300 - 1100 min-1). Results clearly show that fluidised lignite fly ash has the highest potential for carbonation due to its high content of free CaO and fast kinetics of dissolution, and can be employed in mineral carbonation of CO2.
HY2SEPS was an EU-funded project directed at the reduction of CO2 emissions. The principal objective of the project was to develop a hybrid membrane-adsorptive H2/CO2 separation technique that would form an integral element of the pre-combustion process. Specific tasks included the derivation of simplified mathematical models for the membrane separation of H2/CO2 mixtures. In the present study one of the developed models is discussed in detail, namely that with the countercurrent plug flow of the feed and the permeate. A number of simulations were carried out concerning the separation of binary mixtures that may appear following steam conversion of methane. The numerical results were then compared with the experimental data obtained by FORTH/ICEHT. The estimated fluxes of pure CO2, H2, CH4 and N2 are shown alongside those measured experimentally as a function of temperature and CO2 partial pressure in Figs 2 - 7. It is concluded that, in general, CO2 flux increases monotonically with both temperature and CO2 partial pressure. It is also found that the fluxes of hydrogen, methane and nitrogen reach a minimum at a temperature slightly above 323 K. Overall, a good agreement was obtained between the simulations and experiments.
Results are presented concerning the separation of the mixtures of carbon dioxide, nitrogen and oxygen in membrane modules with modified polysulphone or polyimide as active layers. The feed gas was a mixture with composition corresponding to that of a stream leaving stage 1 of a hybrid adsorptivemembrane process for the removal of CO2 from dry flue gas. In gas streams containing 70 vol.% of CO2, O2 content was varied between 0 and 5 vol.%. It is found that the presence of oxygen in the feed gas lowers the purity of the product CO2 in all the modules studied, while the recovery depends on the module. In the PRISM module (Air Products) an increase in O2 feed concentration, for the maximum permeate purity, led to a rise in CO2 recovery, whereas for the UBE modules the recovery did not change.
Thermodynamic principles for the dissolution of gases in ionic liquids (ILs) and the COSMO-SAC model are presented. Extensive experimental data of Henry’s law constants for CO2, N2 and O2 in ionic liquids at temperatures of 280-363 K are compared with numerical predictions to evaluate the accuracy of the COSMO-SAC model. It is found that Henry’s law constants for CO2 are predicted with an average relative deviation of 13%. Both numerical predictions and experimental data reveal that the solubility of carbon dioxide in ILs increases with an increase in the molar mass of ionic liquids, and is visibly more affected by the anion than by the cation. The calculations also show that the highest solubilities are obtained for [Tf2N]ˉ. Thus, the model can be regarded as a useful tool for the screening of ILs that offer the most favourable CO2 solubilities. The predictions of the COSMOSAC model for N2 and O2 in ILs differ from the pertinent experimental data. In its present form the COSMO-SAC model is not suitable for the estimation of N2 and O2 solubilities in ionic liquids.