In the literature the occurrence of thymomas in goats varies from 0.7 to 25%, depending on the study. Therefore the current investigation was carried out to determine the prevalence of thymoma in goats in Poland. Between 2007 and 2018 at the Warsaw Veterinary Faculty 399 goat autopsies and ultrasound examinations of the chest in other 145 goats were performed. Mediastinal tumors were diagnosed during post mortem examination in 2 goats. Additionally, ultrasound examination of the chest revealed a large mass close to the heart in the thoracic cavity in 1 case. This goat was euthanized and an autopsy confirmed a mediastinal tumor. Histopathological examination, with immunohistochemical tests to anti cytokeratin, p63 and p40 confirmed thymomas in all three cases. In our study thymomas were found in 0.5% (95% CI: 0.1% to 1.8%) of examined goats and they represented the most common malignancy in this species.
A computational approach to analysis of wave propagation in plane stress problems is presented. The initial-boundary value problem is spatially approximated by the multi-node C⁰ displacement-based isoparametric quadrilateral finite elements. To integrate the element matrices the multi-node Gauss-Legendre-Lobatto quadrature rule is employed. The temporal discretization is carried out by the Newmark type algorithm reformulated to accommodate the structure of local element matrices. Numerical simulations are conducted for a T-shaped steel panel for different cases of initial excitation. For diagnostic purposes, the uniformly distributed loads subjected to an edge of the T-joint are found to be the most appropriate for design of ultrasonic devices for monitoring the structural element integrity.
This paper addresses the problem of road safety regarding barrier placement as relative to the curb. A short summary of existing regulations is presented. Numerical simulations using the explicit finite element system Ls-Dyna are shown. In the analysis, variable distance between the barrier and the curb is assumed. The obtained result reveals that the distance has little impact on the working width of the barrier.
Characteristics of the microstructure of corrosion-resistant cast 24Cr-5Ni-2.5Mo duplex steel after introduction of 0.98, 1.67 and 4.3% Si were described. Based on the test results it has been found that silicon addition introduced to the corrosion-resistant cast two-phase duplex steel significantly reduces austenite content in the alloy matrix. Increasing silicon content in the test alloy to 4.3% has resulted, in addition to the elimination of austenite, also in the precipitation of Si-containing intermetallic phases at the grain boundaries and inside the grains. The precipitates were characterized by varying content of Cr and Mo, indicating the presence in the structure of more than one type of the brittle phase characteristic for this group of materials. The simulation using Thermo-Calc software has confirmed the presence of ferrite in all tested alloys. In the material containing 4.3% Si, the Cr and Si enriched precipitates, such as G phase and Cr3Si were additionally observed to occur.